The NVIDIA GeForce 910M is an entry-level DirectX 12 compatible graphics card announced in late 2015. Its core is based on the 28nm GF117 chip (Fermi architecture) and is equipped with 64-bit DDR3 memory. The 910M is a renamed GeForce 820M, which already was based on the the old GT 620M, GT 720M and GeForce 710M.
The GF117 is based on the optimized GF108 Fermi chip (GeForce GT 540M) and offers 96 shaders, 16 TMUs and 4 ROPs. Each shader core is clocked twice as fast as the rest of the graphics chip, a technique known as hot clocking. More detailed information on Fermi can be found on the GT 435M GPU page.
It should be noted that the GF117 does not offer dedicated graphic ports and can therefore only be used in conjunction with Optimus.
The 820M supports GPU Boost 2.0, which can automatically overclock the card if the laptop cooling system allows it.
The shader cores (also called CUDA cores) can be used for general calculations with APIs such as CUDA, DirectCompute 2.1 and OpenCL. PhysX is theoretically possible, but the 910M is too slow to handle both PhysX and 3D rendering in modern games. 3D Vision is not supported according to Nvidia.
The power consumption of the Geforce 910M should be similar to the old 820M and GT 720M. As a result, the GPU is best suited for notebooks 13 inches in size or greater. The efficiency however cant be compared to a modern Maxwell based GPU like the GeForce 920MX.
The Nvidia GeForce 940MX is a mid-range laptop graphics card with DirectX 12 support (FL 11_0). It has been announced in the first quarter of 2016 and is the refresh of the GeForce 940M. Compared to the older card, the new one is based on the same chip but now supports faster GDDR5. Therefore, it is similar to the Maxwell GPU in the Microsoft Surface Book but with more memory and higher clock speeds. However, most notebook vendors will use the slower DDR3 version of the 940MX that clocks only a few percent faster than the old GeForce 940M (1122 versus 1072 MHz base clock e.g.).
For the GDDR5 version of the 940MX there appears to be also a variant with the GM107-B chip with 512 shaders instead of the 384 but lower clock speeds. The 940MX in the Acer Aspire E5-774G e.g. featured 512 shader cores (GM107) clocked at 795 - 861 MHz. The Dell Inspiron 17 7778 version however had the GM108 chip with 384 shaders clocked at 1083 - 1189 MHz.
The performance greatly depends on the used graphics memory and chip. According to our benchmarks (see below), the DDR3 version is very similar to the old 940M (due to only minor increased clock rates). The GDDR5 version however pushes ahead 20% (even 30% if paired with a fast desktop quad-core, but we lack 940M reference scores). Therefore, demanding games from 2015 should run fluently in low to medium settings and WXGA resolution.
The TDP of the card should be rated at about 15 to 30 Watt (depending on the version, clock speeds and memory). Therefore, the GPU is best suited for laptops from 13-inch and up.
Average Benchmarks NVIDIA GeForce 940MX → 204%n=27
- Range of benchmark values for this graphics card - Average benchmark values for this graphics card * Smaller numbers mean a higher performance 1 This benchmark is not used for the average calculation
The following benchmarks stem from our benchmarks of review laptops. The performance depends on the used graphics memory, clock rate, processor, system settings, drivers, and operating systems. So the results don't have to be representative for all laptops with this GPU. For detailed information on the benchmark results, click on the fps number.