NVIDIA GeForce MX330 vs NVIDIA GeForce GTX 590 vs NVIDIA GeForce MX450

NVIDIA GeForce MX330

The Nvidia GeForce MX330 is a dedicated entry-level mobile graphics card for laptops. It was released in February 2020 and is basically a renamed Geforce MX250 / GeForce MX150 / desktop GeForce GT 1030. It uses the same GP108 chip as the MX250 (GP108-655-A1 e.g.). It offers the same 384 CUDA cores as the MX250 and MX150 and also the clock speeds only increased slightly (+12 MHz Boost = 0.8% for the 25 Watt version). The dedicated GDDR5 graphics memory is connected via a 64 Bit memory bus and clocked at 3500 MHz (7000 MHz effective) leading to maximal bandwidth of 56 GB/s. Again there is a 25 Watt and slower 12 Watt (low power) variant.

In Nvidia drivers the GeForce MX330 appeared with the hardware ID 1D16.

The GP108 chip is manufactured in a 16 nm FinFET process and offers a number of new features, including support for DisplayPort 1.4 (ready), HDMI 2.0b, HDR and improved H.265 video de- and encoding (PlayReady 3.0). 4K HDR with Netflix however won't run due to the minimum 3 GB graphics memory that is required. Compared to the bigger Pascal chips, the small GP108 does not support Simultaneous Multi-Projection (SMP) for VR and G-Sync. A full list of improvements and the new Pascal desktop GPUs is available in our dedicated Pascal architecture article.

The performance of the GeForce MX330 should be identical to the MX150 and MX250 of previous years. See our GeForce MX250 page for gaming benchmarks. Nvidia states on the product page that the MX330 offers 2x of the performance of a Intel Iris Plus Graphics G7 in an i7-1065G7 (vs 2.5x of the MX350).  Therefore, very demanding games like Red Dead Redemption 2 will not run smoothly, older and less demanding games like Fifa 20 or Farming Simulator 19 however should run fine in medium settings (see below for our benchmark results with different laptops). The low power version (see below) will be clearly slower however.

There is a low power version N17S-LP with a TGP of 12 Watt (up 2 Watt from 10 Watt of the LP MX250) and a "normal" 25 Watt N17S-G3. The performance of both variants should clearly differ. The low power variant offers relatively slow clock rates of 746 - 936 MHz (base - Turbo), where the 25 Watt G3 variant is clocked at 1531 - 1594 (similar to the MX250 and +70% boost clock versus the LP variant).

NVIDIA GeForce GTX 590

The Nvidia GeForce GTX 590 is a high-end desktop graphics card that was announced early 2011. It is based on two GF110 chips (Fermi architecture) in SLI on a single board. Compared to two GTX 580 in SLI, the GTX 590 offers reduced clock rates and therefore is a bit slower.

NVIDIA GeForce MX450

The Nvidia GeForce MX450 (N18S-G5, N18S-G5-B, N18S-LP codename) is a dedicated entry-level mobile graphics card for laptops. It uses the same TU117 chip as the GeForce GTX 1650 but with a reduced memory bus of 64 Bit. Furthermore, the MX450 is the first mobile GPU with PCIe Gen 4 x4 support. 

Currently four different versions are available with different specifications and performance:

N18S-G5-B: GBD-128 Package, 1395 - 1575 MHz, GDDR6 5001 MHz, 28.5 W
N18S-G5: GB2E-64 Package, 1395 - 1575 MHz, GDDR6 5001 MHz, 25 W
N18S-G5: GB2E-64 Package, 1395 - 1575 MHz, GDDR5 3501 MHz, 25 W
N18S-LP: GB2E-64 Package, 720 - 930 MHz, GDDR6 5001 MHz, 12 W

Especially the LP = Low Power variant is significantly slower than the typical 25 Watt variant.

The 25 Watt GDDR6 N18S-G5 should be up to 20% faster than a GeForce GTX 1050 but of course below a GTX 1650 (Max-Q). Therefore, demanding games like Horizon Zero Dawn should run lowest settings. Less demanding games like F1 2020 can be played in medium to high settings and full HD.

The TU117 chip is manufactured in 12nm at TSMC and thanks to the relatively low power consumption (TGP specified between 12 and 28.5 W) the dGPU is also suited for thin and light laptops. Mostly it is intended as an additional graphics card for Tiger Lake-U based laptops.