NVIDIA GeForce MX230 vs NVIDIA GeForce GTX 1060 (Desktop) vs NVIDIA GeForce GTX 1050 (Desktop)

NVIDIA GeForce MX230

The Nvidia GeForce MX230 is an entry-level dedicated  laptop graphics card with DirectX 12 support (FL 12_1) based (most likely) on the Pascal architecture (and not Maxwell as the older MX130). Similar to the faster MX250, the MX230 is based on the GP108 chip.

Features

The GP108 chip is manufactured in a 14 nm FinFET process at Samsung (LPP) and offers a number of new features, including support for DisplayPort 1.4 (ready), HDMI 2.0b, HDR and improved H.265 video de- and encoding (PlayReady 3.0). 4K HDR with Netflix, however, wont run due to the minimum 3 GB graphics memory that is required. Compared to the bigger Pascal chips, the small GP108 does not support Simultaneous Multi-Projection (SMP) for VR and G-Sync. A full list of improvements and the new Pascal desktop GPUs is available in our dedicated Pascal architecture article.

Performance

Thanks to the newer Pascal architecture, the MX230 is significantly faster than the old GeForce MX130 (Maxwell based). Demanding games of 2019 run only in lowest resolution and detail settings and may stutter (e.g. Anno 1800 or Rage 2 ran with under 30fps in our benchmarks). Less demanding games like Overwatch, Fifa 19 or Rocket League, however, can be played in higher detail and resolution settings without stuttering (see benchmarks below).

Power Consumption

The MX230 is manufactured in 14nm at Samsung and due to the low shader count and 64 Bit memory bus, the power consumption is rather low. Therefore, the chip can be also used for small and thin laptops. In our power tests, the faster MX250 needed 22% more power (Furmark load) and the old MX130 even 38% more. The integrated UHD Graphics 620 needed on average only 17% less power at a much lower performance.

NVIDIA GeForce GTX 1060 (Desktop)

The Nvidia GeForce GTX 1060 is a graphics card for desktops and high end laptops (upcoming, see our article for the mobile GTX 1060 for benchmarks and specs). It is based on the Pascal architecture and manufactured in 16 nm FinFET at TSMC. The GPU is be based on the smaller GP106 chip. In laptops it has the codename N17E-G1 and will be the successor to the old GTX 970M (predecessor). The laptop version should be launched in August 2016. The desktop version is already out.

The performance of the 6 GB version is on par with an older GeForce GTX 980 (desktop and laptop). Therefore, 1080p gaming at highest detail is currently the best use case for the card. A comprehensive review of the desktop GeForce GTX 1060 Founders Edition with 6 GB GDDR5 can be found here. Beware, the upcoming 3 GB desktop variant should feature 128 shader less but clocked slightly higher. Still the performance should be definately slower than the 6 GB version.

NVIDIA GeForce GTX 1050 (Desktop)

The Nvidia GeForce GTX 1050 is an entry level graphics card for desktops based on the Pascal architecture. It uses the same GP107 chip as the GTX 1050 Ti, but with only 640 instead of 768 shaders. The chip is manufactured at Samsung in 14 nm (opposed to the 16 nm TSCM based Pascal chips of the 1060 and up). The performance and specs should be similar to the GTX 1050 laptop version, that will be released later (early 2017). Compared to the faster GTX 1050 Ti, the 1050 offers less shaders (640 instead of 768) and only 2 GB of GDDR5 (instead of the 4 GB of the 1050 Ti).

Gaming benchmarks by Nvidia state that the GTX 1050 is about 30% faster on average than the Radeon RX 460 with 2 GB VRAM. The 4 GB version of the RX 460 should be about 10% slower and the older GTX 950 should reach a similar performance level as the new GTX 1050. Therefore, the GTX 1050 should be ideal for 1080p gaming with high detail settings (but not max settings).