NVIDIA GeForce GTX 1050 Ti (Desktop) vs NVIDIA GeForce GTX 980M SLI vs NVIDIA GeForce GTX 1050 (Desktop)

NVIDIA GeForce GTX 1050 Ti (Desktop)

The Nvidia GeForce GTX 1050 Ti (N17P-G1) for desktops is an entry level gaming graphics card that was announced late 2016. It is based on the GP107 chip using the Pascal architecture and manufactured in 14nm FinFET at Samsung (the bigger Pascal chips are manufactured in 16nm at TSMC). Usually it is equipped with 4 GB GDDR5 memory with a 7 Gbps data rate. The mobile GTX 1050 Ti version should be announced later (beginning of 2017) and feature similar specs.

The performance of the GTX 1050 lies between the Radeon RX 460 and the RX 470 on a similar level of the old GeForce GTX 960 (or 970M). Therefore, the card is most suited for 1080p gaming at high detail settings (but not maximum settings).

See our extensive review of the MSI GeForce GTX 1050 Ti for more information on power consumption, benchmarks and noise level.

NVIDIA GeForce GTX 980M SLI

The NVIDIA GeForce GTX 980M SLI is a high-end DirectX 11-compatible graphics solution for laptops, consisting of two GeForce GTX 980M. Each card has a 28 nm GM204 GPU based on the Maxwell architecture, which is the same chip as found on the GTX 970M as well as several desktop cards. The clocks for the SLI-setup are usually identical to a single GTX 980M (1038 MHz GPU, 1250 MHz memory).

With SLI, each card renders a single frame (AFR mode). Therefore, it may suffer from micro stuttering in low fps ranges of 30 fps. This happens because of different timespans between two frames (e.g., irregular delays between sequential frames).

Architecture

GM204 is based on Nvidia's Maxwell architecture, which replaces the previous Kepler generation. Among other changes, Nvidia have restructured the streaming multi processors (SMM) in order to increase workload and efficiency. Now each SMM contains only 128 shader units and 8 TMUs, which is noticeably less than an equivalent Kepler GPU. The GM204 features four GPCs, and each consists of four SMMs. But, in the GeForce GTX 980M, Nvidia have deactivated 4 of 16 SMMs. As a result, only 1536 shader ALUs and 96 TMUs are active. In addition, there are 64 ROPs in four clusters with 16 units each.

The memory interface has a bandwidth of 256-bits (4x 64 bit) for each of the two GPUs. Thanks to an improved compression algorithm, the connection to the GDDR5 memory should be significantly more efficient per MHz. Furthermore, the L1 (96 KB per SMM) and L2 caches (2 MB) have been significantly increased to lower the needed bandwidth. Compared to the mid-range GM107, the newer and larger GM204 has several additional features and changes. Aside from the improved polymorphic engine in the SSMs, it is also the first Nvidia chip to support DirectX 12 Feature Level 12_1.

Performance

With good driver support, SLI almost doubles the performance of a single card. The GTX 980M SLI outperforms the GeForce GTX 970M SLI by about 30 percent and is the fastest mobile graphics solution in late 2014. Compared to the former GTX 880M SLI, the advantage is even bigger (40 - 50 percent). Thus, the GTX 980M SLI is powerful enough to run even the most demanding games with highest details, AA/AF and resolutions exceeding FullHD.

Features

Most of the features are identical to the GeForce GTX 800M series. With the GTX 980M, there can be up to 4 active displays possible, but this will likely decrease due to Optimus. Displays can be connected with a maximum resolution of 3840 x 2160 pixels via DisplayPort 1.2 or HDMI 2.0 (no HDCP @ 4K). HD audio formats like Dolby True HD and DTS HD can be sent to a compatible receiver as bitstream. As with previous models, 3D Vision is not supported with Optimus.

The updated video processor VP6 supports the usual formats like H.264 and can also decode and encode H.265 with a resolution of up to 4K via the NVENC API. Several parallel streams, such as picture-in-picture in a Blu-Ray movie, are also possible.

Further features of the GTX 900M series, which are also partly supported by older cards, include Battery Boost (longer battery life during gaming), Shadowplay (recording of gaming videos up to 4K60p and 130 Mbit/s) and Gamestream (game streaming on Shield console). More information on these features are available here.

Power Consumption

The power consumption of each GeForce GTX 980M including its MXM board and memory should be about the same as a GTX 880M with a specified TDP of 122 W, leading to a total TDP of about 240 W. Given the significantly higher performance, this can be considered a massive increase in performance-per-watt. Nevertheless, the SLI setup can only be used in very large and heavy gaming notebooks with powerful cooling systems. Under low load, dynamic clock rates help the GPUs to save energy.

NVIDIA GeForce GTX 1050 (Desktop)

The Nvidia GeForce GTX 1050 is an entry level graphics card for desktops based on the Pascal architecture. It uses the same GP107 chip as the GTX 1050 Ti, but with only 640 instead of 768 shaders. The chip is manufactured at Samsung in 14 nm (opposed to the 16 nm TSCM based Pascal chips of the 1060 and up). The performance and specs should be similar to the GTX 1050 laptop version, that will be released later (early 2017). Compared to the faster GTX 1050 Ti, the 1050 offers less shaders (640 instead of 768) and only 2 GB of GDDR5 (instead of the 4 GB of the 1050 Ti).

Gaming benchmarks by Nvidia state that the GTX 1050 is about 30% faster on average than the Radeon RX 460 with 2 GB VRAM. The 4 GB version of the RX 460 should be about 10% slower and the older GTX 950 should reach a similar performance level as the new GTX 1050. Therefore, the GTX 1050 should be ideal for 1080p gaming with high detail settings (but not max settings).