Nothing Phone 3a and 3a Pro full spec sheet shows more similarities than differences

The Nothing Phone (3a) series is only a few weeks away from launch, and save for details about pricing and availability, there's no info that has not been leaked. Now, the full spec of both the Nothing Phone (3a) and Nothing Phone (3a) Pro has surfaced, and it shows that both phones are more alike than similar.

Posted by Android Headlines, the two Nothing Phone (3a) phones will have a 6.77'' FHD+ display with a 120Hz refresh rate, a high brightness mode of 1,300 nits and a peak brightness of 3,000 nits. As seen in the leaked photos, the two phones will have a punch hole for the front-facing camera. It has also been reported that they will be protected by Panda Glass, an alternative to Corning's Gorilla Glass.

As reported earlier, Nothing's new phones will be powered by a Qualcomm chip — the Snapdragon 7s Gen 3. However, RAM and storage configuration will differ. The pro model will be available in a single variant with 12GB of RAM and 256GB of storage while the standard model will be available to buy in 8GB or 12GB RAM variants with 128GB or 256GB of storage.

The two phones will have a triple camera setup that includes a 50MP primary camera with OIS, an 8MP ultrawide angle camera, and a 50MP telephoto camera, also with OIS. The difference between the two phones is that the Phone (3a) will have a 2x telephoto lens while the Phone (3a) Pro will have a 3x telephoto lens. The Pro model will also have a 50MP front-facing camera while the non-pro model will ship with a 32MP selfie camera.

As is the case with previous Nothing phones save for the CMF Phone 1, there won't be a microSD card slot. They also won't have an audio jack but will have dual SIM support. Other identical features are a 5,000mAh battery capacity, support for 50W wired charging, Nothing OS 3.1 based on Android 15, and an IP64 dust and water resistance rating.