Oppo Find X10 Pro Max speaker test reveals distortion and audible rattling

Oppo brought the Find X10 and Find X10 Pro Max to Europe last month, following their September debut in China. Priced from €1,799, the Pro Max features three 200 MP rear cameras, MediaTek’s Dimensity 9600 Pro processor and symmetrical stereo speakers. For a Reddit user, that speaker setup became a deal-breaker when a buzzing noise became noticeable during Zoom calls, prompting us to investigate the issue with audio measurements on our own device.
The Reddit user bought two white 16 GB/1 TB phones from official Oppo dealers and noticed buzzing on both. Certain voices during Zoom calls made it particularly noticeable, and the user could also reproduce the noise by playing a tone around 800 Hz using an online tone generator, with both the generator and phone volume set to maximum. Getting replacement phones did not help either, as all three sealed units offered by Oppo in two batches had the same problem. The user also heard buzzing on two shop display units, meaning all seven Chinese-market phones they checked showed the issue. They declined the replacements and returned the original two phones.
We tested our European Find X10 Pro Max to see whether it showed the same buzzing reported on Chinese-market units. Using an Earthworks M23R measurement microphone, a Focusrite Scarlett audio interface and ARTA software, we recorded the speaker output at 80% volume. Playing an 800 Hz tone produced audible buzzing and rattling from the left speaker, even when the phone was held freely in the hand. Spectrum analysis showed harmonic distortion, with extra tones at multiples of 800 Hz that were not part of the original test signal. The fifth harmonic at 4,000 Hz was particularly prominent, measuring approximately 22 dB below the original 800 Hz tone. At 700 Hz, these additional tones were considerably weaker relative to the test signal, indicating less distortion than at 800 Hz.
At the same 80% volume setting, the right speaker did not produce the audible buzzing or rattling we heard on the left. Spectrum analysis still showed stronger harmonics relative to the test tone at 800 Hz than at 700 Hz, indicating increased distortion at 800 Hz. However, these additional tones were less pronounced than in the left-speaker recording, including a much weaker fifth harmonic at 4,000 Hz.
Oppo advertises symmetrical stereo speakers on the Find X10 Pro Max, meant to deliver more evenly balanced sound from the top and bottom of the phone. A WekiHome teardown shows the hardware behind that arrangement, with an AAC Technologies 1510X unit at each end. Both contain N’Bass acoustic material, designed to improve bass by making their small acoustic chambers behave more like larger enclosures. However, our European unit still produced audible rattling at 800 Hz, with the recordings showing strong harmonic distortion during the same test.
Possible causes include mechanical resonance within the speaker module or housing, distortion as the speaker diaphragm moves further at high volumes, poorly tuned digital signal processing (DSP), or manufacturing variations. In a follow-up post, the owner said Oppo engineers suspected that a waterproofing membrane was hitting the speaker diaphragm at high volumes. Our recordings cannot confirm that explanation. We tested one European unit under acoustic conditions that were not fully controlled, so comparisons with additional devices would be needed to assess how widespread the problem is. We have reached out to Oppo for comment.
Source(s)
Reddit, NotebookCheck Tests









